Drill
In a world of greater density of circuitry, and increasing cost pressures, the Uniline 2000 delivers critically needed levels of versatility, precision, speed and efficiency to the printed circuit board industry. The result: A modular system that offers simplicity in operation, higher speed, greater accuracy — and significantly lower cost per hole. The Uniline 2000 is ideal for drilling high precision multi-layer boards.
Jet Technologies, Inc.
Specifications
| Machine Base | Fine-grain, black granite guideway, straightness within ±0.000040" (±1 micron) |
| Axis Positioning | Split axis system: Table motion along the Y-axis, spindle carriage along the X-axis. |
| Table/Carriage | Precision recirculating ball linear rails. |
| Leadscrews | X, Y and Z recirculating pre-loaded ball screws. |
| Precision Z-axis Module | Precision assemblies incorporating an air bearing linear guide, preloaded leadscrew and flexure coupling and Excellon air-bearing spindle. |
| Table Speed | 1,000"/min (25.4 m/min) |
| Drilling Accuracy | ±0.0007" typical (±0.0175 mm) per Excellon Dynamic Accuracy (EDA) test |
| Position Accuracy | ±0.0002 inch (±0.005mm) |
| Position Repeatability | ±0.0001 inch (±0.0025mm) |
| Maximum Panel Size | With edge clamps: 24.0" x 30.0" ( 610 x 762 mm) Without edge clamps: 24.5" x 30.0" (622 x 762 mm) |
| Minimum Panel Size | With edge clamps: 12.0" x 14.0" ( 305 x 355 mm) |
| Spindle Specifications | Air bearing spindles (Driller/15,000 - 110,000 RPM) |
| Drill Bit Sizes | 0.0039"- 0.250" (0.10 mm-6.35 mm) common shank 0.125" (3.175 mm) |
| Controller | UCS (SUN Micro Systems' Sparc station with Object Oriented Programming) and additional microprocessors for intelligent motion control. |
| Laser Tool Check (LTC) | Monitors every drill bit before and after each stroke, detecting broken bits instantly. |
| Tool Management System (TMS) | 240 Tools |
| Tool Metrology Gauge (TMG) | Laser driven tool metrology gauge, measures drill diameter and dynamic run-out of the ringed drill bit and calibrates z-axis for depth control. |
| Autoload | Cart |